Bashing in bushings

A12mm piece of piping was helpful to seat the bushings properly where the bushings were deeper than the box wall.

Using an m8 bolt and a vice on one side of the box I was able to use the tubing and a hammer on the other side of the box to seat it properly

I avoided having to shave the bushings

I like bashing shaved bushes… it is my favorite passtime laughing%20(1)

What casings do you have to bash bushes into? All of my nylon cases, the bushes just pop out if you poke them… and put them back in (or bearings) with a thumb?

Are you talking metal cases? pop

The Ra split just needed a hammer

The mk tac needed the sleeve because the she bushings are wider than the box wall.

1 Like