Easy way to install anti reverse on MK tac gearbox

Works like a charm every time…

Note, you do need to bend up the spring 90 deg on the end that sits against the gearbox.

7 Likes

Nice trick with the screwdriver blade. Beats holding the latch back with one finger while trying to get the bevel gear seated.

Nice bro …,…,…

Just as another option…
I had my wife use this screwdriver handle to hold the top tab, while I replaced the gears.
Once it was all in the reverse latch didn’t go anywhere.

I’m not sure if it’s because my anti reverse spring is to strong but I have to hold the bevel gear down until i put the top half of the box on which I have to be very quick doing because the second I let go it spits out the anti reverse level and bevel. Definitely can’t let go of it like he does in the video.

Has anyone else had this issue and know a solution?

If I use the stock spring that came with the blaster it’s no problem but I’m not sure if I should be using the heavier one that came with the metal gears

1 Like

Nothing new lots of us have this problem

2 Likes

Ooo I like that! Definitely going to get myself some of them. Thanks @Rattler

2 Likes

If you have a 3D printer

2 Likes

Adding 3D printer to the list of endless tools to acquire :joy:

2 Likes

Did you try bending the end up at that sits against the box about 45deg upwards?

Helps hold the spring in

2 Likes

my mk92 has been a dream to pull apart and back together again. everything stays in place omg so happy

1 Like

I use a clip with a notch cut in it.


1 Like