HK416 gas block measurement


I’m planning on purchasing a HK416 gas block but I’m wondering if I could use a different type of handguard at the same time.

Would it be ok if anyone could send me the exact measurements of the gas block (above) (including the diameter of the hole for the barrel, length, width, height etc) before I buy it?

If you have the stock gas block from ldt, you could try modifying it?

I filed down the square corners till its smooth and rounded so it can now slide into most aftermarket hk416 handguard

Next step Im going to cut off the front part so the outer barrel can go through.

1 Like